I created a connection to Verizon DSL manually, which worked. Solid as a rock, no interruptions, wireless all over the place.Ĭons: Technical horror story: my computers recognized the router when hooked up via Ethernet cables but couldn't connect to the Internet. Pros: Nice design, quick physical setup, simple instructions, and the convenience of being both a modem and a router. I had to disconnect my old modem overnight so the IP address would be release from my old modem, and then plug in my new dlink modem and go into the dlink browser and create new wan setting and enter VPI=0, VCI=35,MAC encapsulation,Routing=LLC/SNAP Bridging,Obtain IP Address Automatically,Connection type=MER,Service name=mer_0_35(default),Servicd category=UBR(UBR without PCR),Service state=enabled, nat enabled,Firewall=enabled,IGMP Multicast enabled,wan service enabled, Quality of service=disabled, user/password=admin/admin to start. ![]() I have verizon dsl with dhcp, no pppoe or pppoa, which means i get a dynamic ip address from verizon. It was a battle to get them both to work together, but I found a solution to the problem.įirst of all auto-connect might not work for some people but manual configuration will work, the settings below is for verizon. ![]() ![]() I called D-Link tech support and Verizon. I was using actiontech.Ĭons: It took awhile to get it set up. I sell the mess out of D-Link at work, but we just do not sell this model.
0 Comments
Leave a Reply. |